Contents
Contents-1
1 Getting Started
Setting up the Oscilloscope 1-4
To inspect package contents 1-5
To inspect options and accessories 1-8
To clean the oscilloscope 1-11
To adjust the handle 1-12
To power-on the oscilloscope 1-13
To adjust the waveform intensity 1-14
To connect the oscilloscope analog probes 1-15
To compensate your analog probe 1-16
To use the digital probes (mixed-signal oscilloscope only) 1-17
To connect a printer 1-21
To connect an RS-232 cable 1-21
To verify basic oscilloscope operation 1-22
Getting started using the oscilloscope interface 1-23
Using Quick Help 1-25
Selecting a language for Quick Help when the oscilloscope starts up 1-25
Selecting a language for Quick Help after you have been operating the
oscilloscope 1-26
Loading an updated language file from floppy disk 1-27
2 Front-Panel Overview
Important Oscilloscope Considerations 2-3
54620/40-series Oscilloscope Front Panels 2-7
Front-Panel Operation 2-10
Interpreting the display 2-11
To use analog channels to view a signal 2-12
To use digital channels to view a signal 2-13
To display signals automatically using Autoscale 2-14
To apply the default factory configuration 2-15
To adjust analog channel vertical scaling and position 2-16
To set the vertical expand reference for the analog signal 2-17
To Next Page
Loading...
Need help?
General
