To Next Page

To Previous Page

74 Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide

4 Math Waveforms

2 If f(t) is not already shown on the Function softkey, press the Function

sofkey and select f(t): Displayed.

3 Use the Operator softkey to select an operator or transform.

For more information on the operators, see:

• "Math Operators" on page 76

• "Math Transforms" on page 78

• "Math Filters" on page 94

• "Math Visualizations" on page 96

4 Use the Source 1 softkey to select the analog channel on which to

perform math. You can rotate the Entry knob or repetitively press the

Source 1 softkey to make your selection. If you choose a transform

function (differentiate, integrate, FFT, or square root) the result is

displayed.

5 If you select an arithmetic operator, use the Source 2 softkey to select

the second source for the arithmetic operation. The result is displayed.

6 To re- size and re- position the math waveform, see "To adjust the math

waveform scale and offset" on page 75.

TIP

Math Operating Hints

If the analog channel or math function is clipped (not fully displayed on screen) the

resulting displayed math function will also be clipped.

Once the function is displayed, the analog channel(s) may be turned off for better viewing

of the math waveform.

The vertical scaling and offset of each math function can be adjusted for ease of viewing

and measurement considerations.

The math function waveform can be measured using [Cursors] and/or [Meas].

Agilent Technologies InfiniiVision 3000 X-Series User Manual

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series