Agilent Technologies Medalist i3070 5i Series User Manual

3-6 i3070 Series 5i Help
Test Development
Figure 3-4 Bottom Fixture: Maximum Height
Figure 3-5 Bottom Fixture: Tooling Pin Bushing
A: The tooling pin bushing should not lean into the conveyor belt area.
B: The bushing should be flush with the probe plate.
C: If any part of the bushing interferes with the conveyor, it must be cut
away.

Agilent Technologies Medalist i3070 5i Series Specifications

General

Brand	Agilent Technologies
Model	Medalist i3070 5i Series
Category	Test Equipment
Language	English