Need help?Do you have a question about the Agilent Technologies Medalist i3070 5i Series and is the answer not in the manual?
General| Brand | Agilent Technologies |
|---|---|
| Model | Medalist i3070 5i Series |
| Category | Test Equipment |
| Language | English |
Provides essential safety guidelines and hazard warnings for operating the system.
Introduces the Medalist i3070 Series 5i ICT system and its capabilities.
Details the main hardware components of the Medalist i3070 system.
Explains the functions and buttons of the manual control panel.
Describes the Medalist i3070 software and LCD Touch Panel program.
Provides a step-by-step guide to powering on and starting the Medalist i3070 Series 5i.
Details the correct procedure for powering off and shutting down the Medalist i3070 Series 5i.
Explains the different operational modes available on the LCD touch panel.
Details how to use the Maintenance mode for system calibration and setup.
Describes how to use Debug mode for positioning the press and checking settings.
Outlines the five main tasks involved in test development for the i3070 Series 5i.
Provides guidelines for board placement, top/bottom fixtures, and guide pins.
Covers procedures for setting up and debugging fixtures, including verification.
Details the setup procedures required for board model changes in production.
Explains how to load and run testplans for production testing on the system.
Explains ASRU and System Calibration procedures and their importance.
Provides guidelines for cleaning the testhead, fixtures, and system covers.
Details monthly maintenance schedule and procedures for lubricating system parts.
Introduces Diagnostics (dgn) as the main troubleshooting tool for hardware and failures.
Covers tower light indications and common error messages for system issues.
Details calibration and troubleshooting steps for various sensors (PHS-1 to PHS-17).
Procedure for safely accessing and preparing the testhead for component replacement.
Step-by-step guide for removing and installing ASRU, control, and pin cards in the testhead.
Instructions for removing and installing the press servo motor and related components.
Procedures for replacing ballscrews, bearings, and couplings in the press assembly.
Steps for replacing the conveyor belt on the movable and fixed sides of Zone 1.
Procedures for replacing Zone 1 and Zone 2 conveyor motors.
Procedure for updating the PLC firmware using a memory card.
Instructions for updating the LCD touch panel firmware via an SD card.
Procedure for backing up the LCD touch panel firmware to an SD card.
Provides a detailed list of parts, including part numbers and descriptions.
Lists various electrical diagrams for system components, circuits, and connections.
To Next Page