Subsystem Command Reference 6
N9310A User’s Guide 103
• “Pulse Modulation Subsystem” on page 130
Provides SCPI commands to configure a pulse modulation
signal.
• “I/Q Modulation Subsystem” on page 132
Provides SCPI command to configure the state of the I/Q
modulation.
• “Utility Subsystem” on page 133
Provides SCPI commands to configure the instrument
system settings.
• “Modulation State Subsystem” on page 137
Provides SCPI command to manage the modulator' s state
for AM, FM, Phase modulation, and Pulse modulation.
• “RF Output State Subsystem” on page 138
Provides a command to manage the RF output state for
CW output, RF/Amplitude sweep output, and modulation
output.
• “LF Output Subsystem” on page 139
Provides SCPI commands to configure the LF output.
To Next Page
Loading...
Need help?
General
