Agilent Technologies N9310A User Manual

Key Reference 4
N9310A User’s Guide 65
LF Out
Pressing hardkey reveals a submenu of softkeys to
configure the internal LF (low frequency) generator.
LF Out
On/Off
This softkey toggles the LF output between on and off. Once
you have set the output on, the signal is available at the LF
OUT connector. The and hardkeys do not apply to
this state.
• Default value: Off
• Key sequence: > LF On/Off
LF Out Freq Pressing this softkey sets the frequency of the LF signal. The
active entry area displays the current LF signal frequency.
The allowed frequency range is 20 Hz to 80 kHz.
• Default value: 1.0000 kHz
• Key sequence: > LF Out Freq
LF Out Ampl Pressing this softkey sets the amplitude of the LF signal. The
active entry area displays the current LF signal amplitude.
The allowed amplitude range is 0 to 3 Vpeak, with 1 mV
minimum increment.
• Default value: 500 mV
• Key sequence: > LF Out Ampl
LF Out
AM
LF Out Freq
LF Out Ampl
LF Out
On/Off
Toggles LF output between on and off
Sets LF frequency
Sets LF output amplitude
Mod
On/Off
RF
On/Off
LF Out
LF Out
LF Out

Agilent Technologies N9310A Specifications

General

Brand	Agilent Technologies
Model	N9310A
Category	Test Equipment
Language	English