Agilent Technologies N9310A User Manual

102 N9310A User’s Guide
6 Subsystem Command Reference
Preparing for Use
Subsystem commands include all measurement functions and
some general- purpose functions.
Subsystem Commands Overview
Each of the following subsystems is a set of commands that
broadly corresponds to a functional block of the instrument.
• “Frequency Subsystem” on page 105
Provides SCPI commands to configure frequency related
items.
• “Amplitude Subsystem” on page 109
Provides SCPI commands to configure amplitude related
items.
• “Trigger Subsystem” on page 111
Provides SCPI commands to configure a trigger event.
• “Sweep Subsystem” on page 112
Provides SCPI commands to configure an RF step sweep,
or an LF step sweep, or an amplitude step sweep. It also
provides configuration commands that configure the
trigger mode associated with any step sweep mode.
• “AM Subsystem” on page 122
Provides SCPI commands to configure an AM signal.
• “FM Subsystem” on page 125
Provides SCPI commands to configure an FM signal.
• “Phase Modulation Subsystem” on page 128
Provides SCPI commands to configure a phase
modulation signal.

Agilent Technologies N9310A Specifications

General

Brand	Agilent Technologies
Model	N9310A
Category	Test Equipment
Language	English