172 N9310A User’s Guide
8Supplementary Information
Check the Basics
When you have any difficulties with your signal generator,
please check with the following steps:
✔ Is there power at the power connector?
✔ Is the signal generator turned on? Listen for internal fan
noise to determine if the cooling fan is running. Feel the
right side of the signal generator to check for air flow.
✔ If you use other equipment, cables, and connectors with
your signal generator, make sure you have connected them
properly, and that they are operating correctly.
✔ Review your operation procedures from when the problem
first appeared. Are all the settings correct?
✔ If the signal generator is not functioning as expected,
return the signal generator to a known state by pressing
hardkey.
✔ Are the measurements and the results within the
specification and capabilities of the signal generator?
Refer to the Technical Overview for your generator.
✔ Is the signal generator displaying an error message? If so,
refer to the Chapter 7, “Instrument Messages”.
Preset
WARNING
There are no service components in the signal generator. To prevent
Electrical shock, please don’t disassemble your signal generator.
Contact Agilent Technologies or professional service provider
.
NOTE
A button cell provides power to the real time clock of the signal
generator. It is not rechargeable. If you find your N9310A encounters a
clock defect, please contact your nearest Agilent Customer Contact
Center (CCC) for service.
To Next Page
Loading...
Need help?
General
