Once the position of the fully depressed
brake pedal is confirmed, the cursor will
position itself on the 0% value
Release the brake pedal and record the
position when it is not depressed with the
upper right button
When the position corresponding to 0% is
confirmed, the calibration is completed and
the real-time status of the brake pedal is
displayed again
The calibration of the accelerator pedal is similar to that of the brake pedal, except for the
maximum value of 100%
Calibration is started by pressing and holding
the "1S-CAL" button for one second
The steering wheel is calibrated at 3 points:
When the start of calibration is confirmed,
the cursor is positioned on the -50% value,
which corresponds to the steering wheel
being turned all the way to the left
Turn the steering wheel all the way to the
left and record the first calibration point with
the upper right button
8.3.1.2. ACCELERATOR PEDAL CALIBRATION
45
8. Settings
8.3.1.1. BRAKE PEDAL CALIBRATION
8.3.1.3. STEERING WHEEL CALIBRATION
8.3.1 MOTION SENSORS
8.3. Settings - Box4Move
To Next Page
Loading...
Need help?
General
