Firmware Pages and Descriptions
125
10" Modero Touch Panels
FIG. 113 Wireless Settings page - EAP-TLS security method
Wireless Security - EAP-TLS Settings
SSID (Service Set Identifier): The SSID is the unique name used on the WAP and then assigned to all
panels in a wireless network that are communicating to the same target WAP.
• This is required by the WAP before the panel is permitted to join the
wireless network.
• It is case sensitive and must not exceed 32 characters, which may be any
keyboard character. Make sure this setting is the same for all points in your
wireless network.
• This unique string identifies the network and is the same string for all users
on the same network.
• Use the on-screen keyboard’s Clear button to completely erase any
previously stored SSID information.
Note: In all cases, the SSID of the WAP must be entered. If it is left blank,
the panel will try to connect to the first access point which can be found that
supports EAP. In this situation however, a successful connection is not
guaranteed because the identified WAP may be connected to a RADIUS
server which does not support the specified EAP type and/or may not have
the proper user identities configured.
Identity: When pressed, the panel displays an on-screen keyboard which allows you
to enter an EAP Identity string which is how the panel identifies itself to the
Authentication (RADIUS) Server.
• This information is similar to a username used to login to a secured server
or workstation. This works in tandem with the Password string which is
similar to the password entered to gain access to a secured workstation.
Note: Typically, this is in the form of a username such as: jdoe@amx.com
• Use the on-screen keyboard’s Clear button to completely erase any
previously stored identity/username information.
Certificate Authority: When pressed, the panel displays an on-screen Certificate Authority (CA)
File Location keyboard which allows you to enter the name of the certificate
authority file which is used to validate the server certificate.
The Certificate authority is optional but the client certificate is required.
If a server certificate is used, it should first be downloaded into the panel and
the Certificate Authority field should then be set to the name of that certificate
file. No file path should be used for this setting as all certificates are stored in
a specific directory that the user cannot control or change.
• Use the on-screen keyboard’s Clear button to completely erase any
previously stored network path information.
Required Information:
- SSID (Network Name used by the Target WAP)
- Identity (similar to the Username used for network access)
- Client Certificate file (validates client (panel))
- Private Key and Private Key Password
To Next Page
Loading...
Need help?
General
Weight and Dimensions
