ines M192M / M191M / M245M / M234M / M282M / M281M
3.1.18. CLUTCH WEIGHTS
• Check thickness of friction material on clutch weights.
Min. thickness allowed: 1 mm
• Weights should show no traces of lubricants. If they do,
leak test the driven pulley assembly.
NOTE During running in, clutch weights should have middle
contact surfaces, and be all the same. If not, the clutch may
jerk.
WARNING
Do not open clutch weights with any tools to
avoid load variations in the return springs.
To Next Page
Loading...
Need help?
General
