use and maintenance RSV 1000 R - RSV 1000 RFACT
USA USA
2
© 2006 Piaggio & C. S.p.A. - Noale (VE)
First edition: January 2006
Reprint: September 2066/A
Produced and printed by:
VALLEY FORGE DECA
Ravenna , Modena, Torino
DECA S.r.l.
Registered & Admin. Offices
Via Vincenzo Giardini, 11
48022 Lugo (RA) - Italy -
Tel. 0545-216611
Fax 0545-216610
www.vftis.com
deca@vftis.spx.com
on behalf of:
Piaggio & C. S.p.A.
via G. Galilei, 1 - 30033 Noale (VE) - Italy
Tel. +39 - 041 58 29 111
Fax +39 - 041 44 10 54
www.aprilia.com
FOREWORD
NOTE This manual is an important and
integral part of your vehicle. Keep it with
your vehicle at all times, even if your
vehicle is resold.
aprilia has prepared this manual to
supply you, the user, with correct and
current information. However, since
aprilia constantly improves the design of
its vehicles, there may be slight
discrepancies between your vehicle and
the material given in this manual. If you
have any questions about your vehicle,
contact your Local aprilia Dealer, as he
will have the very latest technical
information available from the factory.
For tests and repairs not expressly
described in this manual, to purchase
aprilia genuine spare parts, accessories,
and other products, and for help with
specific problems, please contact your
Local aprilia Dealer or service center.
These professionals will be able to assist
you promptly and accurately.
Thank you for choosing aprilia. Have a
great ride!
This manual is copyrighted in all countries,
and reproduction of any part thereof or the
complete manual by any print or electronic
means is strictly prohibited.
INTRODUCTION
This manual is divided into sections, chapters
and paragraphs, by subject. The procedures
described are laid out by single operation, and
each operation is indicated by a ♦.
The numbered parts shown in the figures are
identified in the text by the number in
parentheses or the symbol representing them.
Example (the following text is generic and
does not refer to this specific vehicle):
section
MAIN INDEPENDENT CONTROLS
chapter
STEERING LOCK
safety
warning
Never attempt to place the ignition
switch in the locked “ ” (LOCK)
position while the vehicle is moving.
paragraph
OPERATION
operation To lock the steering:
♦ Turn the handlebar completely to the
left or to the right.
position (2)
♦ Turn the key (2) to position “ ”.
symbol “ ”
♦ Press the key and turn it to position “ ”.
♦ Remove the key.
WARNING
To Next Page
Need help?
General
