use and maintenance RSV 1000 R - RSV 1000 RFACT
USA USA
42
CONTROLS AT THE RIGHT HAND GRIP
1) ENGINE STOP SWITCH ( - )
Use the engine stop switch to stop the engine only in case of
emergency. It is essential that you be very familiar with this
control so that you will automatically stop the engine in the
event of a stuck throttle or other engine runaway.
WARNING
If the throttle sticks open, it may cause a collision with
another vehicle, or an upset.
If the throttle sticks, kill the engine with the engine stop
switch located on the right handlebar.
Do not attempt to restart the engine until the throttle has been
repaired and works perfectly. Failure to obey this warning can
lead to a runaway with serious injuries or even death.
Your vehicle is equipped with a double cable throttle. One cable
opens the throttle when you rotate the throttle grip toward you; the
other closes the throttle when you rotate the grip away from you. It
is essential, when you release the throttle grip, that it automatically
return to the idle position. This double cable arrangement
enhances safety by providing for positive closing of the throttle.
WARNING
In the event of a throttle sticking emergency, always kill the
engine using the engine stop switch located near the throttle grip
on the right handlebar. Never use your vehicle if the throttle does
not automatically fully return to the idle position when the throttle
grip is released. Contact your Local aprilia Dealer for repairs.
Failure to heed this warning can lead to a serious accident and
subsequent injury or even death.
WARNING
Do not use the engine stop switch to stop the engine while the
vehicle is moving.
With the switch (1) in the “ ” (ON) position it is possible to
start the engine. The engine can be stopped by moving the switch
(1) to the “ ” (OFF) position.
CAUTION
To stop the vehicle, exclusively use the ignition switch (A).
Leave the engine stop switch (1) in position “ ” (ON) and
use it only in case of emergency.
Do not leave the ignition on if you have stopped for
emergency the engine by moving the engine stop switch to
the “ ” (OFF) position as this will discharge the battery.
When, for emergency, the vehicle has come to rest after
stopping the engine with the engine stop switch, turn the
ignition switch (A) to the “ ” (OFF) position.
2) STARTER SWITCH ( )
When the starter switch is pressed, the starter engages and
the engine will start. For starting, see page 69 (STARTING).
2
1
A
APRum_RSV1000R##06_####.book Page 42 Monday, February 6, 2006 2:48 PM