SBS COSMOS
REFRIGERATOR 10.01.2014 / REV NO: 03
31
1 2
8.3. Before you start using the ice/water dispenser
A separate pump should be used if the water pressure drops below 1 bar or a jug is being
used.
Water system of the refrigerator should be connected to the cold water line. It
should not be connected to hot water line.
No water may be obtained in the initial operation of the refrigerator. This is due
to the air contained in the system. To discharge air from the system, press
dispenser latch for a period of 1 to 2 minutes until water comes from the
Dispenser. Water flow may be irregular at the beginning. Water flow will be
normalized after the air in the system is discharged.
12 hours should pass from the first installation of the refrigerator before cold
water can be obtained.
1-2 days should be waited in order to complete the ice-making process to the
desired amount.
Water mains pressure must be between 1-8 bars for the smooth operation of
ice/water dispenser. You can verify by checking whether 1 glass of water (100
cc) can be filled in 10 seconds.
The first 10 glasses of water should not be consumed.
Approximately 12 hours must pass to obtain ice or cold water from the ice/water
dispenser for the first time. If there is not enough ice in the ice dispenser, ice
may not be obtained from ice dispenser.
The first 30 ice cubes should not be consumed.
Always use the water filter when a jug is not being used.
To Next Page
Loading...
Need help?
General
