• It is used in the container group.
• Remove by either using a flat tipped screwdriver, as shown in the picture, or pushing to
the rear corners.
12.6. WATER DISPENSER ILLUMINATION LED BOARD
12.6.1. Beko Light conducting LED board
Used service number: 1408
• Remove 1 electronic board screw by using a Phillips screwdriver.
• Remove the socket connection.
• Beko LED board is assembled behind the display group.
12.6.2. Arçelik/Blomberg light conducting LED board
Used service number: 1408
• Remove 1 electronic board screw by using a Phillips screwdriver.
• Remove the socket connection.
• Arcelik LED board is assembled behind the container trigger.