A shutdown warning level is a programmable level below the shutdown level.
If one of the measurements exceeds the programmed shutdown warning level, this will also be indicated to
warn the operator before the shutdown level is reached.
Service warning
If the service timer exceeds a programmed value, this will be indicated on the display to warn the operator
to carry out some service actions.
Other warnings
On compressors equipped with an integrated dryer, a warning message will appear if the dew point is too
high or too low for the given ambient temperature.
Automatic restart after voltage failure
The controller has a built-in function to automatically restart the compressor when the voltage is restored
after voltage failure. For compressors leaving the factory, this function is made inactive. If desired, the
function can be activated. The ARAVF label 1079 9932 74 (see section Pictographs) shall be glued near to
the controller. Consult your local supplier.
If activated, and if the controller was in the automatic operation mode, the compressor
will automatically restart when the supply voltage to the module is restored!
3.2 Control panel
Detailed description
Control panel of the Elektronikon controller
Reference Designation Function
1 Display Shows icons and operating conditions.
2 Automatic operation symbol
Instruction book
28 2920 7180 30
To Next Page
Need help?
General
