Barco Coronis 3MP LED User Manual

3. Display installation
3. DISPLAY INSTALLATION
Prior to installing your Coronis 3MP LED Displa y a n d connecting all necessary cables,
make sure to have a suitable display controller physically installed in your computer. If
you are using a Barco display controller, please consult the user guide delivered with it
to do this.
For a list of compatible display controllers, ple ase refer to the latest version of the com-
patibility matrix available on m
y.barco.com (MyBarco > My Support > Healthcare > Com-
patibility Matrices > Barco Systems Compatibility Matrices).
3.1 Unlockin g the heigh t mechani s m
To remove the clip:
1. Position the display with its rear side facing you.
2. Pull the red clip out of the fixation hole in the foot.
3. Keep the clip in the dedicated hole in case the display needs to be shipped later.
3.2 Adjusting the disp lay po sition
To ad just the display position
1. Stand at the front side of the panel and take the panel at both sides.
2. Very important: Tilt the panel upwards before changing the orientation.
K5902060 CORONIS 3MP LED DISPLAY 01/10/2015
9

Barco Coronis 3MP LED Specifications

General

Brand	Barco
Model	Coronis 3MP LED
Category	Monitor
Language	English