3. Display installation
3. Remove the plastic cover with a flathead screw driver.
4. Slide the plastic cover over the neck of the foot.
5. Remove the four screws fixing the foot while supporting the foot.
6. Attach the arm stand firmly to the panel using 4 screws M4 x 8 mm.
3.7 F irst time starting up
Overview
You are now ready to start up your Coron
is 3MP LED Display for the first time.
1. Switch on your Coronis 3MP LED Display as described in "Standby switching", page 16.
2. Turn on the computer connected to your display.
If you have properly installed your display and display controller, the Windows start-up messages will
appear once the boot procedure is finished.
Your Coronis 3MP LED Display will be running in a basic video mode at a default refresh
rate when first time starting up. If you are using a Barco display controller, ple ase con-
sult the user guide de livered with it to install the driv ers, software and documentation.
When this is done, your display will automatically detect the connected video input sig-
nal(s) and apply the correct video mode and refresh rate.
14 K5902060 CORONIS 3MP LED DISPLAY 01/10/2015
To Next Page
Loading...
Need help?
General