R5911227 /02 Coronis Fusion 4MP / 6MP 33
3. Enter the Input Interface Standard Version submenu.
4. Select one of the available versions and confirm.
To obtain full resolution and full refresh rate, DP V1.2 should be selected.
4.23 EDID timings
About EDID timings
Following EDID timings are available for your Coronis Fusion 4MP / 6MP:
• Resolution: Allows to manually modify the resolution of the image source video input signal.
• Refresh Rate: Allows to manually select the refresh rate of the image source video input signal depending
on the maximum refresh rate of the display controller connected to your display.
• Color Depth: Allows to change the color depth to 8 or to 10 bit.
To manually set EDID timings:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources > Input Settings > DisplayPort 1/2 menu.
3. Enter the EDID submenu.
4. Select one of the available settings and confirm.
4.24 Display info
About display info
Your display serial number, native resolution, firmware versions, etc. are available in a dedicated submenu of
the OSD menu.
To retrieve info about your display:
1. Bring up the OSD main menu.
2. Navigate to the About this Display menu to make the information visible on the screen.
4.25 Display status
About display status
The Status submenu of the OSD menu provides info on the current status of your display (runtimes,
temperatures, etc.), the status of the connected image sources (video encoding mode, timings, etc.) and the
current calibration status of your display (display function, luminance, ALC, etc.).
To retrieve the status of your display:
1. Bring up the OSD main menu.
2. Navigate to the Status menu.
3. Enter the Display, Image Sources or Calibration submenu as desired.
Advanced operation
To Next Page
Loading...
Need help?
General