EasyManuals Logo
Home>Bay-Tek>Arcade Game Machines>AXE MASTER

Bay-Tek AXE MASTER User Manual

Bay-Tek AXE MASTER
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
62
Minimize load on power supply and isolate short
Unplug the power supply cables going to the Power Distribution Board.
This will leave the power supply, motherboard, and monitor left plugged in together.
If power supply, motherboard, and monitor now turn on:
Plug in the Power Distribution Board to power supply, but unplug all of the outputs from the board.
Turn on game and verify the 12 volts is good.
Then plug in one component at a time to power supply to locate short.
If power supply still does not power on:
Replace power supply (A5PS1021), or motherboard. (AAMB13-HD/AXM)
POWER SUPPLY DIAGNOSTICS
1.) Verify AC power to game. Check power strip in front door. The rocker switch should be illuminated.
2.) Check connection to power supply.
3.) Ensure Power Supply switch is set to 115V (or 230V)
(Some model power supplies may not have this)
4.) Ensure Power switch is on.
5.) Ensure fan is turning.
- If power supply fan is turning and there is no 12 Volt out:
Check power supply cables to the Power Distribution Board.
This board takes the power in, and directs it to the different 12 volt loads.
- Replace power supply if this board is not receiving 12 volts. (A5PS1021)
- Unplug all power out connectors from the right side of the Power Distribution Board.
Turn on game and if it boots correctly, plug one cable in at a time until the issue is
found.
- If power supply fan is not turning, then continue to Verify Power to Motherboard
Power In from Power Supply
AACB5156
Power Dist. Board
Verify Power to Motherboard
The motherboard will turn on power supply.
If your game has no 12 volts, it may be the motherboard not turning on.
Also - there may be a 12 volt short somewhere in cabinet that is not allowing the power supply to turn on.
AAMB13-HD/AXM
Make sure the 8 pin power connector is plugged in.
(2 of 4 pin connectors together)
As well as 24 pin power in connector.
AAMB12-HD/AXM
Make sure the 4 pin power connector is plugged in.
(Black, Black, Yellow, Yellow)
As well as 24 pin power in connector.
OR

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bay-Tek AXE MASTER and is the answer not in the manual?

Bay-Tek AXE MASTER Specifications

General IconGeneral
BrandBay-Tek
ModelAXE MASTER
CategoryArcade Game Machines
LanguageEnglish

Related product manuals