71
HOW TO CHANGE SOFTWARE ON MB13
Axe Master games can use 2 different motherboards.
The MB12 was the original motherboard which became obsolete and
was changed to an MB13 during March 2023.
This is the MB13 motherboard
These instructions will detail how to change software on the MB13.
This is the M.2 Drive as a hard drive with software.
This M.2 Drive is located on the bottom, underneath the motherboard.
Remove this screw with a small #1 Phillips screwdriver.
Slide the M.2 new software drive into the slot on the
motherboard as shown.
Using a small # 1 screwdriver, re-insert the screw into the
motherboard to secure the software.
To Next Page
Loading...
Need help?
General
