63
Determine if Bill Acceptor has power:
Turn game ON—The bill acceptor should make noise as stacker cycles and
green lights on outside bezel should flash.
If NO power:
Use meter to measure 12 VDC voltage at cable going into Bill Acceptor from
front I/O Aux Board
If power is OK:
Clean Bill Acceptor path to make sure there is nothing jamming
unit.
Check dipswitch settings on side of acceptor.
Make sure switch # 8 is OFF for Always Enable
ERROR CODES
Count the number of flashes on front bezel of Bill
Acceptor and follow on Bill Acceptor chart for
repair instructions.
Note: There are many different models and brands of Bill Acceptors that are used on redemption games.
Your Bill Acceptor may differ from the unit shown. Standard DBA is MEI # AE2454-U5E Part # A5AC9101
BILL ACCEPTOR DIAGNOSTICS
Outputs: Inputs:
Q1 (PD1) Game counter PD4 Menu Button
Q2 (PD0) Tickets counter PC6 Select Button
Q3 (PD6) Coin Lockout PD7 Ticket Notch
PE6 Ticket Enable PB4 Coin In
PB5 DBA In
D15 (A1) Low Ticket Switch Input
Q3
PB5
Q3
PB4
PD7
PE6
Q2
PC6
A1
PD4
Q1
AACB9605-CBL
= +12 VDC = +5 VDC
= Ground = Output
= Input
I/O AUX BOARD PINOUT
To Next Page
Loading...
Need help?
General
