BPAP Series User Manual V1.0
17 / 58
WARNINGS!
• The device is powered on for use when the power cord and power adapter is connected.
The Knob turns the blower On / Off.
• Use of the device at an AC voltage beyond the stated range (see Section 5 ―AC Power
Consumption‖) may damage the device or cause device failure.
• Connect to appropriate power for proper operation of the device.
• Inspect the power cord often for any signs of damage. Replace a damaged cord
immediately.
IMPORTANT TIPS!
• After interruption and restoration of the power supply, the device will restore its
pre-interruption working status automatically.
• To remove AC power, disconnect the power cord from the power outlet.
11.4 Connecting to Power Cord Locker
(1) Insert the power cord locker into the device, as shown in Fig. 11-5, and then rotated to
the left for assembly to the device.
DC Inlet
Power Cord Locker
Fig. 11-5
(2) Open the power cord locker, plug the power cord to the power supply, and press the
locker downward to fix the power cord into the power port.
Power Adapter
Power Cord
DC Inlet
Power Cord Locker
Fig. 11-6
The function of the locker is to prevent the power cord falling off from the power port.
To Next Page
Loading...
Need help?
General
