To Next Page

To Previous Page

BPAP Series User Manual V1.0

32 / 58

Fig. 16-2

Fig. 16-3

Note: The above interface only applicable to the device does not activate the SmartC,

SmartA or SmartB. If the SmartC, SmartA or SmartB is enabled, and the symbol will

appear in the status bar at the top of the screen, as shown in Fig. 16-4.

Fig. 16-4

The first icon on the upper part of the screen indicates the Preheat Function Icon, the

second icon indicates the Accessorie, and the third icon indicates Mask Setup Icon,

the fourth icon indicates the Report Interface Icon, the fifth icon indicates the

Initial Setup Icon. As you turn the Knob , the cursor switches among the five icons.

Note: As the humidity levels is off, the Preheat Function Icon will become gray, as

shown in Fig. 16-2.

16.1.2 Bringing up the Initial Setup Interface

After the display screen displays the Main Interface shown in the Fig. 16-1, turn the Knob

. When the cursor is on the icon

, press the Knob , the screen displays the Initial

Setup Interface of the Patient Menu, as shown in Fig. 16-5.

Other manuals for BMC G3 LAB

Questions and Answers:

Need help?

Do you have a question about the BMC G3 LAB and is the answer not in the manual?

General