from the onboard electrical sys-
tem.
Remove rubber tensioning
strap 1 from holder at bottom
and pull out battery 2 some-
what.
Run engine of donor vehicle
during jump-starting.
Begin by connecting one end
of red jump lead to positive ter-
minal 3 of discharged battery
and other end to positive termi-
nal of donor battery.
Connect black jumper cable to
negative terminal of supporting
battery and then to a suitable
grounding point of this motor-
cycle.
Start engine of motorcycle with
discharged battery in usual
way; if engine refuses to start,
wait a few minutes before re-
peating attempt to protect
starter and supporting battery.
Allow both engines to idle for a
few minutes before disconnect-
ing jump leads.
First disconnect jumper ca-
bles from negative terminal
and from grounding point re-
spectively, then from positive
terminal 3.
To start the engine, do not
use start sprays or similar
items.
Installing right fairing side panel
( 92)
Battery
Maintenance instructions
Correct upkeep, recharging and
storage will prolong the life of
the battery and are essential if
warranty claims are to be consid-
ered.
Compliance with the points be-
low is important in order to maxi-
mize battery life:
8
89
z
Maintenance
To Next Page
Loading...
Need help?
General
