23.29
Installing gearbox shafts
L Note:
If the input shaft has to be shimmed, do not install
the input-side bearing until all measurements have
been completed.
•
Heat the output shaft bearing point to 100 °C.
•
[1993 model year] First insert the input shaft (1).
•
Push sliding sleeve (2), BMW No. 23 4 622, onto
the output shaft.
•
[1993 model year] Insert the idler shaft and out-
put shaft (3) into the gearbox housing together.
•
[Clean Bearing] Install spacer (5).
a page 23.22
•
[from 1994 model year on] Insert the input, idler
and output shafts into the gearbox housing to-
gether.
•
With gentle blows of a plastic-faced hammer,
check that bearing is firmly seated.
e Caution:
Do not strike the seat of a Clean Bearing shaft, as
otherwise the bearing might no longer be correctly
seated on the locking ring.
•
Install oil baffle plates (4).
e Caution:
After installation of the oil baffle plates, turn the
gears and check for ease of movement..
X Tightening torque:
Oil baffle plate retaining screws
(clean thread + Loctite 573, also apply Loctite 573
to the sealing face on the oil baffle plate where it
contacts the gearbox housing)....................... 9 Nm
3
1
23 4 622
4
2
j
100
v
v
Clean Bearing
Clean Bearing
5
RT230201
To Next Page
Loading...
Need help?
General
