36.10
[RS/R/RT] Removing and installing
rear wheel (cast alloy)
Removing rear wheel
•
[RS] Remove number plate carrier.
•
[RS/ABS] Detach muffler (silencer) mount/press
muffler outwards/carefully remove the rear
wheel.
Installing rear wheel
e Caution:
The spacing washer (1) and the contact faces on the
rear wheel drive and the hub must be clean and free
from grease.
•
[RS/ABS] Press the muffler outwards.
•
Fit rear wheel to rear wheel drive with spacer disc
(1) and insert wheel studs hand-tight.
e Caution:
Only use wheel studs with length code 60.
Do not oil or grease wheel studs!
•
Tighten wheel studs.
•
Install hub cap (2).
L Note:
Insert lug on cover in recess in wheel.
•
Install number plate holder.
•
[RS/ABS] Bolt on the muffler mount.
X Tightening torque:
Screw in wheel studs handtight, then
tighten them in a crosswise pattern
Initial tightening............................................ 50 Nm
Final tightening........................................... 105 Nm
1
2
RS/R/RT
RS/R/RT
RS360040
To Next Page
Loading...
Need help?
General
