32.8
Removing and installing right
handlebar fitting
•
[RS] Remove left side trim.
•
[GS/R] Detach fuel tank and pull it to the rear.
•
[RT] Remove upper section of fairing.
•
Separate connector (1) at brake light switch.
•
Detach brake line and seal off.
e Caution:
Do not allow brake fluid to come into contact with
painted parts of the motorcycle, because brake fluid
destroys paint.
•
Remove combination switch.
•
Unfasten throttle cable cover (2) and disconnect
throttle cable.
•
Unfasten screw (3) and pull out handlebar
weight.
With heated handlebar grips
•
Fold back rubber grip at handlebar fitting end.
•
Unfasten retaining screws for heated handlebar
grip.
•
Separate connector to heated handlebar grip.
•
Unfasten cable shoes at connector.
•
Pull lead through handlebar.
Without heated handlebar grips
•
Cut open rubber grip (4) and pull off.
•
Unfasten clamp screw (5) from fitting housing.
•
Remove handlebar fitting.
•
Install in the reverse order of work.
•
Align slot of handlebar fitting (arrow) with punch-
mark on handlebar.
•
Secure rubber handlebar grip with
Loctite 638 adhesive and surface activator.
e Caution:
Top up brake fluid, bleed brake system.
– Adjustable handlebar – In the center position the
brake hose fitting at the master brake cylinder must
have sufficient clearance
(app. 5 ... 10 mm (0.1969...0.3937in))
from the center section of the handlebar.
If necessary, unfasten the wiring harness.
X Tightening torque:
Brake hose to fitting....................................... 7 Nm
1
2
5
4
3
RSGS/R/RT
GS320020
To Next Page
Loading...
Need help?
General
