1 689 979 672 2012-06-26| Robert Bosch GmbH
Symbols used | EPS 807 / 815 | 27
en
1. Symbols used
1.1 In the documentation
1.1.1 Warning notices - Structure and meaning
Warning notices warn of dangers to the user or people in
the vicinity. Warning notices also indicate the consequenc-
es of the hazard as well as preventive action. Warning no-
tices have the following structure:
Warning
symbol
KEY WORD – Nature and source of hazard!
Consequences of hazard in the event of fail-
ure to observe action and information given.
¶ Hazard prevention action and information.
The key word indicates the likelihood of occurrence and
the severity of the hazard in the event of non-observance:
Key word Probability of
occurrence
Severity of danger if in-
structions not observed
DANGER Immediate impend-
ing danger
Death or severe injury
WARNING Possible impending
danger
Death or severe injury
CAUTION Possible dangerous
situation
Minor injury
1.1.2 Symbols in this documentation
Symbol Designation Explanation
!
Attention Warns about possible property dam-
age.
i
Information Practical hints and other
useful information.
1.
2.
Multi-step
operation
Instruction consisting of several steps.
e
One-step
operation
Instruction consisting of one step.
Intermediate
result
An instruction produces a visible inter-
mediate result.
"
Final result There is a visible final result on com-
pletion of the instruction.
n
458735_27pal
WARNING!
The T-bar used to rotate the flywheel by
hand must not be left inserted in the locat-
ing holes of the flywheel!
Always remove the T-bar before starting!
458735_28pal
WARNING!
Never hold your hand anywhere near the
danger zone around the flywheel!
Disposal
Dispose of used electrical and electronic
devices, including cables, accessories and
batteries, separately from household waste.
1.2 On the product
! Observe all warning notices on products and ensure
they remain legible.
1 681 105 263
458735_26pal
Caution!
¶ Never connect two or more items of electrical
equipment (e.g. CRS 845 trigger unit, solenoid
valve) to the 12/24 V supply terminals of the EPS,
as this could damage the electrical equipment!
¶ Never disconnect or connect electrical equipment
with the EPS switched on.
To Next Page
Loading...
Need help?
General
