5 Transport and storage
5.1 General notes
Damage or injuries and loss of the warranty
due to improper handling!
● Protect the products against moisture and corrosion.
● Avoid putting the products under mechanical load. Do not throw, tilt or
drop the products.
● Only use lifting equipment suitable for the weight of the BA1N energy
storage device.
● Never lift the BA1N energy storage device by the fan housing.
● Use suitable protective equipment and protective clothing during trans‐
port.
5.2 Transport instructions
To protect the BA1N energy storage device against dirt, dust, etc., Bosch
Rexroth recommends transporting it
● up to the prepared installation place
● until it is actually installed in the machine
in its original packaging in which the BA1N energy storage device is delivered
by Rexroth.
To lift the BA1N energy storage device out of the transport crate or to install it
in the machine, use the attached lifting eyebolts.
The lifting eyebolts at least meet the requirements of DIN 580. Before each
transport, ensure that the lifting eyebolts have been screwed down fully to the
contact surface and that your selected lifting equipment and lifting method
does not overstress the lifting eyebolts.
Please comply with DIN 580 on the transport of the BA1N energy
storage device using the attached lifting eyebolts. Non-observ‐
ance of the information in this standard can cause overstress to
the lifting eyebolts and result in personal injury and/or product
damage.
Based on DIN EN 60721-3-2, the tables below specify classifications and lim‐
it values which are allowed for our products while they are transported by
land, sea or air. Refer to the detailed description of the classifications to take
all of the factors which are specified in the particular class into account.
BA1N Kinetic Energy Buffer 15/49
Transport and storage
R911393267_Edition 01 Bosch Rexroth AG
To Next Page
Loading...
Need help?
General
