Brother ADS-2100 User Manual

Confidential
CHAPTER 4 ADJUSTING AND UPDATING SETTINGS
AS REQUIRED AFTER PARTS REPLACEMENT
This chapter describes adjustments and updating of settings, which are required if the main
PCB ASSY and some other parts have been replaced.
CONTENTS
1. IF YOU REPLACE THE MAIN PCB ASSY................................................................... 4-1
1.1 Writing Firmware ...................................................................................................4-2
1.1.1 Checking firmware version......................................................................... 4-2
1.1.2 Writing firmware .........................................................................................4-3
1.2 Setting by Country .................................................................................................4-4
1.3 Initializing the EEPROM of the Main PCB ASSY ..................................................4-4
1.4 Setting Serial Number ...........................................................................................4-5
1.5 Acquiring White Level Data ................................................................................... 4-6
1.6 Setting Double Feeding Sensor Threshold............................................................ 4-6
1.7 Checking Operation after Repair ...........................................................................4-7
2. IF YOU REPLACE THE CIS UNIT ................................................................................ 4-8
2.1 Acquiring White Level Data ................................................................................... 4-8
2.2 Checking Operation after Repair ...........................................................................4-8
3. IF YOU REPLACE THE DOUBLE FEEDING SENSOR ...............................................4-9
3.1 Setting Double Feeding Sensor Threshold............................................................ 4-9
3.2 Checking Double Feeding Sensor Operation ...................................................... 4-10
4. IF YOU REPLACE THE PANEL ASSY....................................................................... 4-11
4.1 Acquiring White Level Data for Second Side CIS Unit ........................................ 4-11
4.2 Checking Operation after Repair ......................................................................... 4-11
5. IF YOU REPLACE THE PICK-UP ROLLER / SEPARATION PAD ............................ 4-12
5.1 Resetting Pick-up Roller / Separation Pad Counters...........................................4-12

Brother ADS-2100 Specifications

General

Film scanning	No
Color scanning	Yes
Grayscale levels	256
Input color depth	30 bit
Maximum scan size	215.9 x 863 mm
Output color depth	24 bit
ADF scan speed (b/w, A4)	24 ppm
Enhanced scan resolution	1200 x 1200 DPI
Optical scanning resolution	600 x 600 DPI
Duplex ADF scan speed (b/w, A4)	48 ipm
Scanner type	Sheet-fed scanner
Product color	Black
Scan to	E-mail, File, Image, OCR, USB
Sensor type	CMOS dual CIS
Scan drivers	ISIS, TWAIN, WIA
Internal memory	256 MB
Scan file formats	JPG, PDF, TIFF
Processor frequency	400 MHz
Scanning noise level	62.5 dB
Daily duty cycle (max)	500 pages
Auto document feeder (ADF) input capacity	50 sheets
Minimum scan area (ADF)	51 x 70 mm
ISO A-series sizes (A0...A9)	A4, A5, A6, A7, A8
Scanning media types supported	Business Card, Plain paper, Plastic Card, Recycled paper, Thick paper, Thin paper, Business card, Plastic card
Maximum ISO A-series paper size	A4
Auto Document Feeder (ADF) media weight	52 - 200 g/m²
USB version	2.0
Standard interfaces	USB 2.0
Input voltage	220-240 V
Power supply type	AC
AC input frequency	50 Hz
Power consumption (off)	0.3 W
Power consumption (standby)	7 W
Power consumption (typical)	18 W
Power consumption (PowerSave)	1.5 W
Package weight	5400 g
Image formats supported	JPG, TIF
Sustainability certificates	ENERGY STAR

Weight and Dimensions

Depth	179 mm
Width	220 mm
Height	299 mm
Weight	3300 g