124
Basic printing procedures
6-1. Basic printing process flow
What are described below are the basic work flows before the start and after the completion of print process.
Fixation of ink
Removing printed
matter
from platen
Remove the print medium from the platen.
Refer to "6-8. Removing printed matter from platen >>P.169".
Fixate the ink onto the print medium.
Refer to "6-9. Fixation of ink >>P.170".
Printing
Start the print operation.
Refer to "6-7. Executing a printing job >>P.167".
Sending/Loading
Print data
Placing print medium
in position
Platen adjustment
Pretreatment for print
medium
To fixate the white ink onto a T-shirt, apply the pretreatment to it beforehand.
If you are not using white ink, you do not need to pretreat print medium.
Refer to "6-3. Pretreating process for print medium >>P.130".
Replace the currently used platen with another one that suits the print medium.
After the platen replacement is completed, adjust the platen's height.
Refer to "6-4. Platen adjustment >>P.143".
Put a print medium on the platen.
Refer to "6-5. Placing print medium in position >>P.152".
Send or load print data to the printer.
Refer to "6-6. Sending/Loading Print Data >>P.155".
Tasks to be performed
before starting print
operation
Before starting printing, perform check and preparation tasks on the printer.
Refer to "6-2. Tasks to be performed before starting print operation >>P.125".
To Next Page
Loading...
Need help?
General
