142
Basic printing procedures
(1) Place the silicone foam, T-shirt and peel-off sheet in position under the heat press first, and fixate the pretreatment
properly.
<TIPS>
ï‚· Water droplets are generated around the heat press to evaporate water content of the pretreatment by the heat of heat
press. Keep your working space clean so that the surface to be coated with the agent will not get wet.
ï‚· A peel-off sheet should be used if needed, depending on the heat press you use.
X009
(2) Remove the T-shirt from the heat press so that the steamy heat will escape from it.
X0097
Water droplets
Heat press
Peel-off sheet
T-shirt
Heat press
T-shirt
Silicone foam
To Next Page
Loading...
Need help?
General
