TROUBLESHOOTING AND ROUTINE MAINTENANCE
22 - 22
Follow these steps to replace the drum unit:
1
Open the front cover.
2
Remove the old drum unit.
Place the drum unit on a drop cloth or
disposable paper to avoid scattering
toner.
3
Hold down the lock lever on the right
and pull the toner cartridge out of the
drum unit assembly.
(See
Replacing the Toner Cartridge,
Page 22-18.)
4
Wait to unpack the new drum unit until immediately before installing it. Place the old
drum unit into the aluminium bag, and then discard it according to local regulations.
5
Reinstall the toner cartridge into the new drum unit. (See Replacing the Toner
Cartridge
, Page 22-18.)
6
Reinstall the new drum unit, keeping the front cover open.
7
Press Clear.
8
Press 1 and when the LCD shows ACCEPTED,
and close the front cover.
Caution
If toner scatters and your hands or clothes get dirty, immediately wipe off or
wash with cold water.
Checking the Drum Life
You can see the percentage of the drum’s life that remains available.
1
Press Menu, 2, 0, 3.
2
For five seconds, the LCD shows the available
percentage of drum life.
Discard the used drum unit according to local regulations. If you are not sure of
them, call your local Sanitation Department. Be sure to seal the drum unit
tightly so toner powder does not spill out of the unit. When discarding used
drum units, keep them separate from domestic garbage.
Even if the remaining drum life is 0%, you may continue to use the drum unit
until you have a print quality problem.
Lock
Lever
To Next Page
Need help?
General
