Chapter 10
70
e Press [a] or [b] to select AM, PM or 24, and then press the number keys to specify two digits
each for the hour and minutes.
To enter 2:45 in the AM/PM format, press [b] to select [PM], and then press [c], then [0] [2]
[4] [5].
f Press [OK]. The main screen appears, and the specified time and date are displayed.
The format for the time and date can be changed. Press [ ] (admin key), select [Setup], then
[Time&Date Form] from the parameters, and then specify settings for [Date Format] and
[Time Format].
Setting the Administrator Password 10
A password can be set so that basic settings specified by pressing [ ] (admin key) cannot easily
be accessed. If a password is set, each time [ ] (admin key) is pressed, a password must be
entered. Access to these parameters can be restricted by setting a password.
a Press [ ] (admin key).
b Press [b], select [Admin Password], and then press [OK].
c Press [b], select [On], and then press [OK].
The password input screen appears.
d Type in the 4-digit password, and then press [OK].
The password is set.
• This parameter can be accessed only when touchpanel A (basic control panel) is set.
• After a password has been set, the password input screen appears when [ ] (admin key) is
pressed. Type in the specified 4-digit password, and then press [OK].
• To cancel the password settings, press [ ] (admin key), type in the password to display the
parameters, and then set [Admin Password] to [Off].
• If you do not remember the password, use [Device settings] in the “Printer Setting Tool” to
return all settings to their factory defaults or specify the password again and apply it. For more
information, see Device Settings on page 27.
To Next Page
Loading...
Need help?
General