Administrator password settings
The administrator password can be set or canceled.
Important
• The administrator password of the printer is set from the time of purchase. It is set in the serial number
of the printer which consists of 9 characters (the first 4 characters are alphabet and the latter 5
characters are number) and is indicated on the seal on the device.
1.
Check that printer is turned on.
2.
Select Setup on the HOME screen.
Using Touch Screen
3.
Select Device settings.
The Device settings screen is displayed.
4.
Select Administrator password settings.
5.
When the confirmation screen of the administrator password setting is displayed, select
Yes.
When the administrator password is not set, the registration confirmation message is displayed. Select
Yes. The message is displayed again. Then, select OK and proceed to step 7.
6.
Select Change administrator password.
When you do not set the administrator password, select Remove administrator password. Select Yes
in the displayed screen. The message is displayed again. Then, select OK.
7.
Select the effective range of the administrator password.
Remote UI and other tools
To change the setting using the remote UI or a certain software, the administrator password needs
to be entered.
LCD, Remote UI, and other tools
To change the setting using the operation panel of this printer, remote UI or a certain software, the
administrator password needs to be entered.
8. Enter the administrator password.
Important
•
When changing the password, the character is limited as follows.
212
To Next Page
Loading...
Need help?
General
