Canon PowerShot SX70 HS User Manual

z Connecting to Printers via Wi-Fi

Establishing a Connection via an Access Point
z The PIN code displayed when you choose [WPS (PIN mode)] in
[Connect with WPS] is entered on the access point. Choose a device
on the [Select a device for connection] screen. For further details, refer
to the user manual included with your access point.
z Sending Images to a Computer Automatically
Sending Images Automatically
z When using auto image transfer, ensure that the battery pack has
sufcient charge. Power saving on the camera is deactivated.
z Any images captured after auto image transfer are not sent to the
computer then. They are sent automatically when the camera is
restarted.
z If auto image transfer to a computer does not begin automatically, try
restarting the camera.
z To stop sending images automatically, choose [Auto send images to
computer] → [Auto send] → [Disable].
z Uploading Images to Web Services
Registering CANON iMAGE GATEWAY
z Make sure initially that your computer or smartphone mail application
is not congured to block email from relevant domains, which may
prevent you from receiving the notication message.
Registering Other Web Services
z If any congured settings change, update camera settings by
registering affected Web services on the camera.
262

Canon PowerShot SX70 HS Specifications

General

Image Processor	DIGIC 8
Optical Zoom	65x
Aperture	f/3.4 (W) - f/6.5 (T)
Connectivity	Wi-Fi, Bluetooth
Shutter Speed	15 - 1/2000 sec
Built-in Flash	Yes
Sensor	1/2.3-inch CMOS
Focal Length	3.8-247mm (35mm equivalent: 21-1365mm)
Video Resolution	4K UHD at 30p
Viewfinder	0.39-type OLED Electronic Viewfinder
LCD Screen	3.0-inch Vari-angle LCD
Battery	LP-E12
Dimensions	127.1 x 90.9 x 116.6 mm
Weight	Approx. 610g (including battery and memory card)
ISO Sensitivity	ISO 100-3200 (expandable to 6400)
Continuous Shooting	10 fps
Ports	HDMI, USB
Image Stabilization	Yes (Optical)