ENG
3
"Carel emeter" +0300044IE rel. 1.5 - 10.11.2017
WARNINGS
CAREL bases the development of its products on decades of experience in
HVAC, on the continuous investments in technological innovations to products,
procedures and strict quality processes with in-circuit and functional testing
on 100% of its products, and on the most innovative production technology
available on the market
. CAREL and its subsidiaries/aliates nonetheless cannot
guarantee that all the aspects of the product and the software included with the
product respond to the requirements of the nal application, despite the product
being developed according to start-of-the-art techniques.
The customer (manufacturer, developer or installer of
the nal equipment)
accepts all liability and risk relating to the conguration of the product in order
to reach the expected results in relation to the specic nal installation and/or
equipment.
CAREL may, based on specic agreements, acts as a consultant for the positive
commissioning of
the nal unit/application, however in no case does it accept
liability for the correct operation of the nal equipment/system.
The CAREL product is a state-of-the-art product, whose operation is specied in
the technical documentation supplied with the product or can be downloaded,
even prior to
purchase, from the website www.carel.com.
Each CAREL product, in relation to its advanced level of technology, requires
setup/conguration/programming/commissioning to be able to operate in
the best possible way for the specic application. The failure to complete such
operations, which are required/indicated in the user manual, may
cause the nal
product to malfunction; CAREL accepts no liability in such cases.
Only qualied personnel may install or carry out technical service on the product.
The nal customer must only use the product in the manner described in the
documentation relating to the product.
In addition to
observing any further warnings described in this manual, the
following warnings must be heeded for all CAREL products:
• Prevent the electronic circuits from getting wet. Rain, humidity and all
types of liquids or condensate contain corrosive minerals that may damage
the electronic circuits. In any case, the product should be used or stored in
environments that comply with the temperature and humidity limits specied
in the manual.
• Do not install the device in particularly hot environments. Too high
temperatures may reduce the life of electronic devices, damage them and
deform or melt the plastic parts. In any case, the product should be used or
stored in environments that comply with the temperature and humidity limits
specied in
the manual.
• Do not attempt to open the device in any way other than described in the
manual.
• Do not drop, hit or shake the device, as the internal circuits and mechanisms
may be irreparably damaged.
• Do not use corrosive chemicals, solvents or aggressive detergents to clean the
device.
• Do not use the product for applications other than those specied in the
technical manual.
All of the above suggestions likewise apply to the controllers, serial boards,
programming keys or any other accessory in the CAREL product portfolio.
CAREL adopts a policy of continual development. Consequently, CA
REL reserves
the right to make changes and improvements to any product described in this
document without prior warning.
The technical specications shown in the manual may be changed without prior
warning.
The liability of CAREL in relation to its products is specied in the CAREL
general
contract conditions, available on the website www.carel.com and/or by specic
agreements with customers; specically, to the extent where allowed by applicable
legislation, in no case will CAREL, its employees or subsidiaries/aliates be liable
for any lost earnings or sales, losses of data and
information, costs of replacement
goods or services, damage to things or people, downtime or any direct, indirect,
incidental, actual, punitive, exemplary, special or consequential damage of any
kind whatsoever, whether contractual, extra-contractual or due to negligence, or
any other liabilities deriving from the installation, use or impossibility to use the
product, even if CAREL or its subsidiaries/aliates are warned of the possibility of
such damage.
DISPOSAL
INFORMATION FOR USERS ON THE CORRECT HANDLING OF WASTE
ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE)
In reference to European Union directive 2002/96/EC issued on 27 January
2003 and related national legislation, please note that:
1. WEEE cannot be disposed of as municipal waste and such waste must
be collected and disposed of separately;
2. the public or private waste collection systems dened by local
legislation
must be used. In addition, the equipment can be returned
to the distributor at the end of its working life when buying new
equipment;
3. the equipment may contain hazardous substances: the improper use
or incorrect disposal of such may have negative eects on human
health and on the environment;
4
. the symbol (crossed-out wheeled bin) shown on the product or on the
packaging and on the instruction sheet indicates that the equipment
has been introduced onto the market after 13 August 2005 and that it
must be disposed of separately;
5. in the event of illegal disposal of electrical and
electronic waste, the
penalties are specied by local waste disposal legislation.
Warranty on materials: 2 years (from production date, excluding
consumables).
Approval: the quality and safety of CAREL INDUSTRIES HQ products are
guaranteed by the ISO 9001 certied design and manufacturing
system.
IMPORTANT: separate as much as possible the probe and digital input
cables from cables to inductive loads and power cables, so as to avoid
possible electromagnetic disturbance.
Never run power cables (including the electrical panel cables) and signal
cables in the same conduits
NO POWER
& SIGNAL
CABLES
TOGETHER
READ CAREFULLY IN THE TEXT!
To Next Page
Loading...
Need help?
General
