Casio fx-3650P User Manual

E-39
3. Press < to resume program execution.
u Program Execution Notes
•Pressing < after program execution finishes causes the same program
to be executed again.
•You can also run a program from the Run Prog screen by using number
keys 1 through 4 to specify a program number (P1 through P4). You
can display the Run Prog screen by pressing t < from the Edit Prog
screen after step 3 of the procedure under “Storing a Program” on page
36.
•You can use the following keys on the currently displayed value while
program execution is paused by the output command (^).
J, I, C, r, F*
*Note that you can use the F key to select the settings shown below
only. Program execution is automatically cancelled if you try to select any
other mode or setting.
Deg, Rad, Gra, Fix, Sci, Norm, Dec, Hex, Bin, Oct
•To cancel further program execution, press t.
u Errors During Program Execution
• If an error message appears on the display during program execution,
press the e or r key to automatically enter the Edit Prog Mode. The
location of the error with the cursor located there will appear on the
display at this time. Determine the cause of the error and edit the program
as required.
•Pressing the t key while an error message is on the display clears the
message and terminates program execution.
600.
Ans
The program number disappears after
program execution is complete.
(Area)

Casio fx-3650P Specifications

General

Type	Scientific
Form factor	Pocket
Housing material	Plastic
Digits	12 digits
Digit comma separator	Yes
Display number of lines	2 lines
Digit comma separator format	Standard (3 digits)
Battery type	LR44
Number of batteries supported	1

Weight and Dimensions

Weight	100 g
Dimensions (WxDxH)	78 x 157 x 12 mm