E-111
Note
The mode that the calculator will enter automatically when you clear an error message
depends on the program’s run mode, as shown below.
Program Run Mode Calculation Mode
COMP Mode or Formula Mode COMP Mode
BASE-N Mode BASE-N Mode
PROG Mode
Clearing an error message will display the editing screen for the program, with the cursor
located at the location where the error was generated so you can correct the problem.
k
File Screen Operations
The Program Menu of the PROG Mode lets you select from among the following screens.
• Prog List screen/ Fmla List screen:
2
(RUN)
Use these screens to select a program or user formula, and run it.
• Prog Edit fi le menu/ Fmla Edit fi le menu:
3
(EDIT)
Use these menus to select a program or user formula, and edit it.
• Prog Delete fi le menu/ Fmla Delete fi le menu:
4
(DELETE)
1
(One File)
Use these menus to select a program or user formula, and delete it.
All of the operations in this section can be performed while any one of the above screens is
on the display.
Important!
The operations in this section assume that one of the six fi le screens is already on the
display.
A
Searching for a Program
Searching for a File Name by Inputting a Character
On a fi le screen, input the fi rst letter of the name of the program you want.
Example: To search for the fi le named “OCTAHEDRON”
Press
5
(O).
5(O)
This will jump to the section of the fi le screen where the names start with the letter you
specifi ed (“O” in this example). The fi rst program with a name that starts with the letter
will be highlighted, indicating that it is selected. You can use
c
and
f
to scroll the
highlighting to the program you want (“OCTAHEDRON” in this example).
Searching for a Program by Scrolling through the List
On a fi le screen, use
c
and
f
to scroll through the program names until the one you
want is highlighted.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
