12
Projector operations are performed using the remote controller that comes with it. Point the remote
controller signal emitter at one of the signal receivers on the projector as you perform remote
controller key operations. The maximum range of the remote controller signal is approximately
5 meters (16.4 feet) (between signal emitter and receiver).
To avoid running down the batteries, store the remote control unit so its keys are not pressed
inadvertently.
Remote Controller
Remote control signal emitter
[P] key
Turns power on or off.
[ESC] key
Press to exit the currently displayed menu or to cancel an
operation.
Cursor keys (///), [ENTER] key
Use the cursor keys to move between menu items, and to
change setting values. Press the [ENTER] key to select a menu
item or to execute a function.
Each of these keys has a specific fixed function. For details,
see the sections that describe key operations in “Operating
the Projector” (pages 14 through 35). For information about
the [MENU] key, for example, see “Using the Setup Menu
(MENU)” (page 26).
These keys are used with network models only. They are
mainly used for File Viewer (page 36) projection operations.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
