Challenger AP11LED User Manual

AP11LCD / AP11LED Manager Guide
AP11LED/LCD-Manager- Rev 02
13
LCD Keypad
How to Set the System
Full Set
When you leave your premises you will need to set the intruder alarm system.
Before setting the system you should ensure that the premises have been completely vacated and
that all doors and windows are closed. Ensure that pets do not have access to the protected areas
as they can cause a false alarm.
Part Set
If your installer has programmed your system for PART SET operation you will be able to set
some zones of the system while others remain unset. Part set operation is often used at night time,
and it will permit you to walk free around the bedrooms while the living area and outside doors
are protected. Your system may have 2 part-set programs called Part 1 and Part 2.
Before Part-setting the system you should ensure that all doors and windows are closed. Ensure
that pets do not have access to the protected areas. Your installer may have instructed you to use
a different keypad to the one normally used to set the system.
Note: · There will be no exit beeps if Silent Exit mode was programmed.
· You should wait until you hear that the exit beep has stopped before assuming that the
system has set.
LCD Remote Keypad :
· System is in Day mode.
·
··
· Enter 4-digit manager or user code and wait later.
e.g. press
·
··
· manager using 3 seconds.
·
··
· user select arm mode
Press key to select Full arm mode,
Or press key to select Part 1 arm mode,
Or press key to select Part 2 arm mode.
Or press key to exit.
·
··
· Exit and check system faults.
System fault could be: Tamper Zone, PA Zone, Fire Zone, Zone N tamper (when EOLR function
enable), CP tamper, Detector Tamper, RKP Tamper, Bell Box Tamper.
Enter your code
*
**
***
****
**
===Welcome ===
Manager
00:01:00 08-Aug
DAY
To Set Select
[Full] [P1] [P2]
0 1 2 3
O IMT
E
S
T
R ES TE

Challenger AP11LED Specifications

General

Brand	Challenger
Model	AP11LED
Category	Alarm system
Language	English