AP11LCD / AP11LED Manager Guide
AP11LED/LCD-Manager- Rev 02
17
1 = Setup Codes
There are 10 user codes can be created and set by LCD Keypad in the system,, all are 4-digit and
can be set to any number from 0000 to 9999. The access codes ensure that only authorized users
can operate the system.
1 = user 1, 2 = user 2, 3 = user 3, 4 = user 4, 5 = user 5, 6 = user 6, 7 = user 7,
8 = user 8, 9 = user 9, 0 = user10.
Managers Code Default - 0123
Default User Codes – None Programmed
Managers Code:
The Managers Code (default 0123) can change all codes and has full access to the option
in the user programming mode.
User 1 – User10 codes:
The user 1 to user 10 codes have the same operation for testing and Setting and Unsetting,
changing their own code.
Holiday code:
The purpose of this code is to allow access to the property whilst the manager is absent. The
Holiday access code is programmed by the Manager and is only valid until the manager use’s
the system. At this point the Holiday code becomes invalid and is no longer accepted by the
control panel.
NOTE:
Entering an invalid user code will operate the code tamper. After 9 incorrect code
entries a full alarm condition will be generated.
To Next Page
Loading...
Need help?
General
