Cisco 11503 - CSS Content Services Switch User Manual

Appendix B Using the Offline Diagnostic Monitor Menu
B-26
Cisco Content Services Switch Administration Guide
OL-5647-02
4. Select option 2 to display the boot configuration.
When check disk is enabled, no state information appears in the
Miscellaneous field of the boot configuration:
***************** IP/MAC Information ***************
IP Address: 10.3.6.58
Subnet Mask: 255.0.0.0
MAC Address: 00-10-58-00-12-ca
***************** PRIMARY **************************
Boot Type: DISK
Boot File: sg0730002
***************** SECONDARY ************************
Boot Type: DISK
Boot File: sg0720104
Press <Enter> to continue...
Configuring Disks in a Two-Disk CSS
The CSS 11501 and the SCM in the CSS 11503 and CSS 11506 contain two
PCMCIA slots for a hard disk or Flash disk. These disks contain the CSS system
software and are also used for logging and storing offline system files. The two
disks are identified by the PCMCIA slots (slot 0 and slot 1) in which they are
installed. Disk 0 is the default storage location for the primary and secondary boot
records in the CSS. The default storage location for log files and core dumps in
the CSS is the specified disk from which the CSS boots (disk 0 or disk 1).
To specify the CSS disk that is to be the storage location for booting (primary and
secondary boot disk), for logging output, and for core dumps:
1. Select option 4 from the Advanced Options menu to configure the disks in the
active SCM.
The CSS prompts you to specify the disk for the primary boot record.
Set Primary-Boot to which PCMCIA slot? (0,1):
2. Enter either 0 for the disk in slot 0 (the default setting) or 1 for the disk in
slot 1.
The CSS prompts you to specify the disk for the secondary boot record.
Set Secondary-Boot to which PCMCIA slot? (0,1):

Cisco 11503 - CSS Content Services Switch Specifications

General

Brand	Cisco
Model	11503 - CSS Content Services Switch
Category	Switch
Language	English