4-12
Cisco 1900 Series Hardware Installation
OL-19084-02
Chapter 4 Installing and Connecting the Router
Power Connections
Power Connections
Warning
Read the installation instructions before connecting the system to the power source.
Statement 1004.
Note The installation must comply with all required electrical codes applicable at the installation site.
Connect your router to a 15 A, 120 VAC (10 A, 240 VAC) circuit with over current protection.
Note The input voltage tolerance limits for AC power are 85 and 264 VAC.
Warning
This product relies on the building’s installation for short-circuit (over current) protection. Ensure that
the protective device is rated not greater than: 15A, 120VAC (10A, 240VAC).
Statement 1005
Warning
Take care when connecting units to the supply circuit so that wiring is not overloaded.
Statement 1018
This section explains how to connect AC or DC power to Cisco 1900 series routers and a console
terminal. It covers the following topics:
• Power Connections, page 4-12
• Connecting WAN and LAN Cables, page 4-13
• Connecting to a Console Terminal or Modem, page 4-16
For cable information and specifications, see the “Network Cabling Specifications” section.
Note To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information for Cisco 1900 Series Routers document.
To Next Page
Loading...
Need help?
General
