CHAPTER
5-1
Cisco 1900 Series Hardware Installation
OL-19084-01
5
Cable Connection Procedures for Cisco 1900
Series Routers
This document describes how to connect your Cisco 1941 integrated services router to a power source
and to networks and external devices. It includes the following sections:
• Power Connections, page 5-1
• Connecting WAN and LAN Cables, page 5-2
• Connecting to a Console Terminal or Modem, page 5-3
For cable information and specifications, see the “Cable Information and Specifications for Cisco 1900
Series Routers” document.
Note To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information for Cisco 1900 Series Routers document.
Power Connections
Warning
Read the installation instructions before connecting the system to the power source.
Statement 1004.
Note The installation must comply with all required electrical codes applicable at the installation site.
Connect your router to a 15 A, 120 VAC (10 A, 240 VAC) circuit with over current protection.
Note The input voltage tolerance limits for AC power are 85 and 264 VAC.
Warning
This product relies on the building’s installation for short-circuit (over current) protection. Ensure that
the protective device is rated not greater than: 15A, 120VAC (10A, 240VAC).
Statement 1005
To Next Page
Loading...
Need help?
General
