Cisco 870 Series User Manual

5-5
Cisco 850 Series and Cisco 870 Series Access Routers Hardware Installation Guide
OL-5331-01
Chapter 5 Initial Configuration
Verifying the Initial Configuration
Step 3 Press Return to display the Router> prompt.
...
flashfs[4]: Initialization complete.
Router>
Step 4 Enter privileged EXEC mode.
Router> enable
Router#
Step 5 For configuration using the CLI, see the applicable configuration procedures in the Cisco 850 Series and
Cisco 870 Series Access Routers Software Configuration Guide.
Step 6 Verify the initial configuration. See the “Verifying the Initial Configuration” section for verification
procedures.
Verifying the Initial Configuration
To verify that the new interfaces are operating correctly, perform the following tests:
• To verify that the interfaces are operating correctly and that the interfaces and line protocol are in
the correct state—up or down—enter the show interfaces command.
• To display a summary status of the interfaces configured for IP, enter the show ip interface brief
command.
• To verify that you configured the correct hostname and password, enter the show configuration
command.
After you have completed and verified the initial configuration, you can configure your Cisco router for
specific functions.
What to Do Next
For information and instructions on how to perform additional configurations for the router, see the
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide.

Cisco 870 Series Specifications

General

Brand	Cisco
Model	870 Series
Category	Network Router
Language	English