Configuring Access Node Control Protocol on Cisco ASR 9000 Series Routers
Configuration Examples for Configuring ANCP on Cisco ASR 9000 Series Routers
QC-108
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
OL-23108-02
Mapping AN ports to VLAN Subinterfaces: Example
The following example shows a unique access node ID being defined:
configure
ancp an-port circuit-id circuit1 interface gigabitethernet 2/0/1/1.1
The following example shows how to display information for a port identified by its subinterface:
show ancp an-port interface gigabitethernet 0/0/0/37.1
AN port circuit-id ccc1:
State UP
UPtime 02:23:45
Time Since Last Message 00:00:00
Encap Type ETHERNET
DSL type ADSL1
DSL Line State SHOWTIME
Number of Mapped Interfaces 3
Neighbor sender-name 0006.2aaa.281b
Neighbor description 7200-client
Configured Rate Adjustment 90%
Actual Downstream Data Rate (kbps) 2500
Effective Downstream Data Rate (kbps) 2250
The following example shows how use the detail keyword to display port information as well as a list
of the interfaces mapped to that port.
show ancp an-port circuit-id ccc1 detail
AN port circuit-id ccc1:
State UP
UPtime 02:31:36
Time Since Last Message 00:00:00
Encap Type ETHERNET
DSL type ADSL1
DSL Line State SHOWTIME
Number of Mapped Interfaces 3
Neighbor sender-name 0006.2aaa.281b
Neighbor description 7200-client
Configured Rate Adjustment 90%
Actual Downstream Data Rate (kbps) 2500
Effective Downstream Data Rate (kbps) 2250
Actual Data Rate Upstream/Downstream (kbps) 2500/2500
Minimum Data Rate Upstream/Downstream (kbps) 0/0
Attainable Data Rate Upstream/Downstream (kbps) 0/0
Maximum Data Rate Upstream/Downstream (kbps) 0/0
Minimum Low Power Data Rate Upstream/Downstream (kbps) 0/0
Maximum Interleaving delay Upstream/Downstream (ms) 0/0
Actual Interleaving Delay Upstream/Downstream (ms) 0/0
Sub-interface Summary: total 3
-----------------------------------------------
Sub-interface Name ifhandle
--------------------------------- ----------
GigabitEthernet0/0/0/37.1 0x0
GigabitEthernet0/0/0/37.11 0x0
GigabitEthernet0/0/0/38.10 0xb80
To Next Page
Loading...
Need help?
General
