Configuring Access Node Control Protocol on Cisco ASR 9000 Series Routers
Configuration Examples for Configuring ANCP on Cisco ASR 9000 Series Routers
QC-109
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
OL-23108-02
The following example uses the statistics keyword to display port message statistics for a specific AN
port:
show ancp an-port circuit-id ccc1 statistics
Port message statistics for circuit-id ccc1:
Port Up 5
Port Down 0
The following example shows how to display port counts by state:
show ancp an-port summary
AN Port Count Summary
------------------------------
State UP 4
State DOWN 0
Config only ports 0
Total 4
# Configured ports 1
# Mapped sub-interfaces 4
The following example shows how to clear message statistics for all AN ports:
clear ancp an-port all statistics
The following example shows how to clear dynamic data for all AN ports:
clear ancp an-port all
The following example show how to clear dynamic data for a specific interface:
clear ancp an-port interface gigabitethernet 0/1/0/10.5
Configuring ANCP Rate Adjustment: Example
The following example shows how to configure a percent factor of 90 with DSL type ADSL, and an
access loop type of Ethernet:
configure
ancp rate-adjustment adsl2 ethernet percent-factor 90
The following example shows how to display generic information about ANCP configuration, along with
neighbor and port counts by state:
show ancp summary
ANCP Summary Information
----------------------------------------------
Capability: Topology Discovery
Server sender-name: 0013:1aff.c2bd
Neighbor count by state:
- 0
SYNSENT 0
SUNRCVD 0
ESTAB 1
----------------------------------
Total 1
To Next Page
Loading...
Need help?
General
