Configuring Hierarchical Modular QoS on Cisco ASR 9000 Series Routers
Configuration Examples for Hierarchical QoS
QC-143
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
OL-23108-02
Configuration Examples for Hierarchical QoS
This section provides the following configuration examples:
• Two-Level Hierarchical Queueing Policy: Example, page 143
• Three-Level Hierarchical Queueing Policy: Examples, page 144
• Three-Parameter Scheduler: Examples, page 148
• Hierarchical Policing: Examples, page 149
• Attaching Service Policies to Physical and Virtual Links: Examples, page 150
• Enhanced Hierarchical Ingress Policing: Example, page 150
Two-Level Hierarchical Queueing Policy: Example
The following example shows a two-level policy applied at the Multilink Frame Relay main interface.
The same policy can be applied at Multilink PPP main interface.
class-map match-any video
match precedence 1
end-class-map
!
class-map match-any premium
match precedence 2 3
end-class-map
!
class-map match-any voice-ip
match precedence 0
end-class-map
!
Step 9
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config-pmap-c-police)#
end
or
RP/0/RSP0/CPU0:router(config-pmap-c-police)#
commit
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
–
Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
–
Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
–
Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Command or Action Purpose
To Next Page
Loading...
Need help?
General
